Systematic Design Of Analog Ip Blocks

Download or read book Systematic Design of Analog IP Blocks written by Jan Vandenbussche and published by Springer Science & Business Media. This book was released on 2013-03-14 with total page 205 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book introduces a design methodology that can help to bridge the productivity gap. Two different types of designs, depending on the design challenge, have been identified. To validate the presented methodologies, the authors have selected and designed accordingly three different industrial-strength applications.

Download or read book Systematic Design of Sigma-Delta Analog-to-Digital Converters written by Ovidiu Bajdechi and published by Springer Science & Business Media. This book was released on 2004-04-30 with total page 216 pages. Available in PDF, EPUB and Kindle. Book excerpt: Systematic Design of Sigma-Delta Analog-to-Digital Converters describes the issues related to the sigma-delta analog-to-digital converters (ADCs) design in a systematic manner: from the top level of abstraction represented by the filters defining signal and noise transfer functions (STF, NTF), passing through the architecture level where topology-related performance is calculated and simulated, and finally down to parameters of circuit elements like resistors, capacitors, and amplifier transconductances used in individual integrators. The systematic approach allows the evaluation of different loop filters (order, aggressiveness, discrete-time or continuous-time implementation) with quantizers varying in resolution. Topologies explored range from simple single loops to multiple cascaded loops with complex structures including more feedbacks and feedforwards. For differential circuits, with switched-capacitor integrators for discrete-time (DT) loop filters and active-RC for continuous-time (CT) ones, the passive integrator components are calculated and the power consumption is estimated, based on top-level requirements like harmonic distortion and noise budget. This unified, systematic approach to choosing the best sigma-delta ADC implementation for a given design target yields an interesting solution for a high-resolution, broadband (DSL-like) ADC operated at low oversampling ratio, which is detailed down to transistor-level schematics. The target audience of Systematic Design of Sigma-Delta Analog-to-Digital Converters are engineers designing sigma-delta ADCs and/or switched-capacitor and continuous-time filters, both beginners and experienced. It is also intended for students/academics involved in sigma-delta and analog CAD research.

Download or read book Systematic Modeling and Analysis of Telecom Frontends and their Building Blocks written by Piet Vanassche and published by Springer Science & Business Media. This book was released on 2005-10-24 with total page 243 pages. Available in PDF, EPUB and Kindle. Book excerpt: To meet the demands of today's highly competitive market, analog electronics designers must develop their IC designs in a minimum of time. The difference between first- and second-time right seriously affects a company's share of the market. Analog designers are therefore in need for structured design methods together with the theory and tools to support them, especially when pushing the performance limits in high-performance designs. Systematic Modeling and Analysis of Telecom Frontends and Their Building Blocks aims to help designers in speeding up telecommunication frontend design by offering an in-depth understanding of the frontend's behavior together with methods and algorithms that support designers in bringing this understanding to practice. The book treats topics such as time-varying phase-locked loop stability, noise in mixing circuits, oscillator injection locking, oscillator phase noise behavior, harmonic oscillator dynamics and many more. In doing so, it always starts from a theoretical foundation that is both rigorous and general. Phase-locked loop and mixer analysis, for example, are grounded upon a general framework for time-varying small-signal analysis. Likewise, analysis of harmonic oscillator transient behavior and oscillator phase noise analysis are treated as particular applications of a general framework for oscillator perturbation analysis. In order to make the book as easy to read as possible, all theory is always accompanied by numerous examples and easy-to-catch intuitive explanations. As such, the book is suited for both computer-aided design engineers looking for general theories and methods, either as background material or for practical implementation in tools, as well as for practicing circuit designers looking for help and insight in dealing with a particular application or a particular high-performance design problem.

Download or read book Design of Very High-Frequency Multirate Switched-Capacitor Circuits written by Seng-Pan U and published by Springer Science & Business Media. This book was released on 2006 with total page 268 pages. Available in PDF, EPUB and Kindle. Book excerpt: Design of Very High-Frequency Multirate Switched-Capacitor Circuits presents the theory and the corresponding CMOS implementation of the novel multirate sampled-data analog interpolation technique which has its great potential on very high-frequency analog frond-end filtering due to its inherent dual advantage of reducing the speed of data-converters and DSP core together with the specification relaxation of the post continuous-time filtering. This technique completely eliminates the traditional phenomenon of sampled-and-hold frequency-shaping at the lower input sampling rate. Also, in order to tackle physical IC imperfections at very high frequency, the state-of-the-art circuit design and layout techniques for high-speed Switched-Capacitor (SC) circuits are comprehensively discussed: -Optimum circuit architecture tradeoff analysis -Simple speed and power trade-off analysis of active elements -High-order filtering response accuracy with respect to capacitor-ratio mismatches -Time-interleaved effect with respect to gain and offset mismatch -Time-interleaved effect with respect to timing-skew and random jitter with non-uniformly holding -Stage noise analysis and allocation scheme -Substrate and supply noise reduction -Gain-and offset-compensation techniques -High-bandwidth low-power amplifier design and layout -Very low timing-skew multiphase generation Two tailor-made optimum design examples in CMOS are presented. The first one achieves a 3-stage 8-fold SC interpolating filter with 5.5MHz bandwidth and 108MHz output sampling rate for a NTSC/PAL CCIR 601 digital video at 3 V. Another is a 15-tap 57MHz SC FIR bandpass interpolating filter with 4-fold sampling rate increase to 320MHz and the first-time embedded frequency band up-translation for DDFS system at 2.5V. The corresponding chip prototype achieves so far the highest operating frequency, highest filter order and highest center frequency with highest dynamic range under the lowest supply voltage when compared to the previously reported high-frequency SC filters in CMOS.

Download or read book Design of Wireless Autonomous Datalogger IC's written by Wim Claes and published by Springer Science & Business Media. This book was released on 2006-03-30 with total page 211 pages. Available in PDF, EPUB and Kindle. Book excerpt: Design of Wireless Autonomous Dataloggers IC's reveals the state of the art in the design of complex dataloggers, with a special focus on low power consumption. The emphasis is on autonomous dataloggers for stand-alone applications with remote reprogrammability. The book starts with a comprehensive introduction on the most important design aspects and trade-offs for miniaturized low-power telemetric dataloggers. After the general introduction follows an in-depth case study of an autonomous CMOS datalogger IC for the registration of in vivo loads on oral implants. After tackling the design of the datalogger on the system level, the design of the different building blocks is elaborated in detail, with emphasis on low power. A clear overview of the operation, the implementation, and the most important design considerations of the building blocks to achieve optimal system performance is given. Design of Wireless Autonomous Dataloggers IC's discusses the design of correlated double sampling amplifiers and sample-and-holds, binary-weighted current steering DACs, successive approximation ADCs and relaxation clock oscillators and can also be used as a manual for the design of these building blocks. Design of Wireless Autonomous Dataloggers IC's covers the complete design flow of low-power miniaturized autonomous dataloggers with a bi-directional wireless link and on-board data processing, while providing detailed insight into the most critical design issues of the different building blocks. It will allow you to design complex dataloggers faster. It is essential reading for analog design engineers and researchers in the field of miniaturized dataloggers and is also suitable as a text for an advanced course on the subject.

Download or read book Dynamic Characterisation of Analogue-to-Digital Converters written by Dominique Dallet and published by Springer Science & Business Media. This book was released on 2006-03-08 with total page 291 pages. Available in PDF, EPUB and Kindle. Book excerpt: The Analogue-to-digital converter (ADC) is the most pervasive block in electronic systems. With the advent of powerful digital signal processing and digital communication techniques, ADCs are fast becoming critical components for system’s performance and flexibility. Knowing accurately all the parameters that characterise their dynamic behaviour is crucial, on one hand to select the most adequate ADC architecture and characteristics for each end application, and on the other hand, to understand how they affect performance bottlenecks in the signal processing chain. Dynamic Characterisation of Analogue-to-Digital Converters presents a state of the art overview of the methods and procedures employed for characterising ADCs’ dynamic performance behaviour using sinusoidal stimuli. The three classical methods – histogram, sine wave fitting, and spectral analysis – are thoroughly described, and new approaches are proposed to circumvent some of their limitations. This is a must-have compendium, which can be used by both academics and test professionals to understand the fundamental mathematics underlining the algorithms of ADC testing, and as an handbook to help the engineer in the most important and critical details for their implementation.

Download or read book Matching Properties of Deep Sub-Micron MOS Transistors written by Jeroen A. Croon and published by Springer Science & Business Media. This book was released on 2006-06-20 with total page 214 pages. Available in PDF, EPUB and Kindle. Book excerpt: Matching Properties of Deep Sub-Micron MOS Transistors examines this interesting phenomenon. Microscopic fluctuations cause stochastic parameter fluctuations that affect the accuracy of the MOSFET. For analog circuits this determines the trade-off between speed, power, accuracy and yield. Furthermore, due to the down-scaling of device dimensions, transistor mismatch has an increasing impact on digital circuits. The matching properties of MOSFETs are studied at several levels of abstraction: A simple and physics-based model is presented that accurately describes the mismatch in the drain current. The model is illustrated by dimensioning the unit current cell of a current-steering D/A converter. The most commonly used methods to extract the matching properties of a technology are bench-marked with respect to model accuracy, measurement accuracy and speed, and physical contents of the extracted parameters. The physical origins of microscopic fluctuations and how they affect MOSFET operation are investigated. This leads to a refinement of the generally applied 1/area law. In addition, the analysis of simple transistor models highlights the physical mechanisms that dominate the fluctuations in the drain current and transconductance. The impact of process parameters on the matching properties is discussed. The impact of gate line-edge roughness is investigated, which is considered to be one of the roadblocks to the further down-scaling of the MOS transistor. Matching Properties of Deep Sub-Micron MOS Transistors is aimed at device physicists, characterization engineers, technology designers, circuit designers, or anybody else interested in the stochastic properties of the MOSFET.